Bentel Omnia 4 Spezifikationen PDF herunterladen (Seite 111)

Only the MASTER control panel can change the identification number (1

through 128) of electronic keys.

To configure a control panel as SLAVE: use a valid electronic key and follow Ad-

dress 421 procedure. SLAVE control panels can program the options of valid

electronic keys only. The factory default programming of the control panel is MAS-

TER.

Options (Addresses 423 to 425)

Addresses 423 and 425 are for Options programming. During Options

programming the keys will take on the meaning shown in the following ta-

bles: Key OFF = option disabled; Key ON = option enabled.

Add. Keys OPTIONS DEFAULT

423 Auto-reset partition no. 1

Auto-reset partition no. 2

Auto-reset partition no. 3

Auto-reset partition no. 4

False Digital Key signalling

Immediate Mains Failure

signalling

Key reader LEDs permanently

active

Telephone line check

425 Reset tamper memory denied to

User Code

Reset alarm memory denied to

Installer Code

Arming denied with battery

trouble

Enable Installer Code for User Code

PIN programming via PC

Enable Installer

Code PIN for

User Code PIN

programming

via PC

When this option is enabled the Installer can program all the User Code

PINs via PC (the Main User PIN will not be required). However, the In-

staller Code PIN must be entered in the Installer Code page. The words

Freed PIN Programming on the title bar of the PIN Programming window

will flash to signal option enabled.

This option can be enabled from the keypad only.

WARNING Use of Freed PIN programming lowers the security level

of the system, and is done at the Installers own risk. The customer

must be informed of the possible consequences.

PROGRAMMING FROM KEYPAD 111

1 2 ... 106 107 108 109 110 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare

Bentel Omnia 4 Spezifikationen Seite 111

Kommentare zu diesen Handbüchern