Bentel Omnia 4 Spezifikationen PDF herunterladen (Seite 78)

Record / Playback

The control panel must be in Service mode (as per maintenance). Use the jumper

13 (refer to page 10) or insert a valid service digital key into any key reader: Serv-

ice mode will be signalled by fast flashing on the PRG LED on the keypad.

Select Message

The 8 configurations (corresponding to the 8 messages) can be seen on

the green LEDs at intervals of 1 second (see Message chart below). LED 1

is the nearest to the microphone.

To select Message:

1. Hold down the buttons 42 and 43.

2. Release the buttons when the LEDs show the required configuration.

Message No. 1 2 3 4 5 6 7 8

LENGTH (sec.) 15 15 15 15 7 7 7 7

LED 1 ON OFF OFF OFF OFF ON ON ON

LED 2 OFF ON OFF OFF ON OFF ON ON

LED 3 OFF OFF ON OFF ON ON OFF ON

LED 4 OFF OFF OFF ON ON ON ON OFF

Record Alarm Messages

NormaVOX2 can record up to 8 messages. Messages 1, 2, 3 and 4 are

each 15 seconds long. Messages 5, 6, 7 and 8 are each 7 seconds long.

To record the Alarm Message ----speak at a distance of approximately 20

cm from the microphone.

1. Hold down the button 43 ----the 4 green LEDs will flash to signal the elaps-

ing message time.

2. Press the button 43 twice to stop the recording. Recording will stop auto-

matically when the message recording time expires.

Playback

To playback the message:

1. Press the button 42 - the 4 green LEDs will start flashing.

2. Press the button 42 twice to stop playback. Playback will stop automat-

ically when the message time expires.

Programming

The parameters on the Telephone and Events pages (refer to the "Program-

ming" chapter) must be programmed carefully, in order to assure proper func-

tioning of the Voice board. Note that the parameters in the Events page

determine the activation of the Digital communicator and / or the Telephone Di-

aller, and the event calls. If several events occur simultaneously the correspond-

ing messages will be played successively during the same telephone call.

78 Security System Control Panels Omnia8/4

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 111 112

Keine Kommentare

Bentel Omnia 4 Spezifikationen Seite 78