Bentel Omnia 4 Spezifikationen PDF herunterladen (Seite 17)

INSTALLATION

System mounting

Main Unit The Main unit can be installed anywhere on the protected premises. How-

ever, it should be within easy reach of all the connection cables, and

should not be on view.

Follow the steps in the installation instructions carefully, and refer to the il-

lustration on page 10 and the diagram below.

1. Unfasten the screws 1 and remove the cover.

Contents: Main Unit PCB; keypad; terminal board for the connections to

the Mains; balance resistors; small plastic bag containing the screws (for

wall mounting) and reverse locking circuit board supports.

2. Fit the reverse locking circuit board supports to the backplate, and then lock

the PCB, and the NormaVOX2 board into place (refer to the figure below).

3. Fit the transformer (not supplied) onto the screws on the backplate, use

M3x10 screw nuts (not supplied) to fix it in place. If the transformer does

not fit onto the screws, use the 4 holes (∅ 5.10 mm). The transformer must

comply with the required specifications (refer to fig. 8), and must be fitted

firmly in place, for maximum stability of the configuration.

4. Check for cable conduits and water pipes before drilling holes. Use the

holes 3 on the backplate as a drill pattern.

5. Pass the cables through the cable holes 10 and mount the unit (holes 3).

Figure 7 Reverse locking circuit board supports

INSTALLATION 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Keine Kommentare

Bentel Omnia 4 Spezifikationen Seite 17