Bentel Omnia 4 Spezifikationen PDF herunterladen (Seite 72)

Modem menu

The Modem menu is for programming and management of remote control

panels, via the OmniaMOD modem. The Modem must be connected to a

serial port of the PC (refer to "Connection of control panel to PC and Mo-

dem to PC").

Connecting To program and manage a remote control panel:

1. Select the Connecting option from the Modem menu to open the Con-

nection Management window.

2. Enter the control panle telephone number in the Telephone Number field.

3. Program the Disable Tone Check, Double Call and Callback options as

required.

4. Enter the Installer Code PIN in the Installer Code field.

5. Select the Dial button to start the connection procedure.

The connection sequence will be shown in the box at the bottom of the

Connection Management window. Do not select the OK button until the

connection has been established, and the following message appears:

OMNIA8/4 ACK

Installer code recognized

6. Select the OK button to confirm ----the Connection window will close.

The Send and Load buttons (on every page), and the Send and Load op-

tions from the Programming menu, will send and load data to and from

the control panel that is connected via modem.

Teleservice calls to the control panel cannot be answered unless the User en-

ables the Teleservice option (refer to "Enable/Disable Teleservice" in the

USER MANUAL).

Figure 39 Connection

72 Security System Control Panels Omnia8/4

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 111 112

Keine Kommentare

Bentel Omnia 4 Spezifikationen Seite 72