Bentel Omnia 4 Spezifikationen PDF herunterladen (Seite 48)

Codes

This option opens the Codes page. The codes and digital keys give the In-

staller and User access to the system.

Each code comprises:

- PIN (4 to 6 digits)

- Type (MAIN USER, USER, PATROL, DURESS, DISABLED)

- Enabled Partitions

- Type A Arming mode

- Type B Arming mode

24 codes

available

The Control panel manages up to 24 codes. Codes 1 through 23 are for

the users. Special code 24 is for the Installer (refer to "Installer Code" para-

graph). The Installer can program the parameters of all the codes but can-

not program the Code PINs.

Keypads and

User Code PINs

Keypads can be assigned to different partitions (refer to Config. page).

Code PINs and keypads can control only the partitions where they are en-

abled. Therefore, an enabled Code PIN entered on an disabled keypad

will have no effect. This dual level of control allows a Code PIN to be valid

on certain partitions when used on one keypad, and on other partitions

when used on another. This method of Code PIN and keypad program-

ming simplifies usage, as the same arming procedure can be used on dif-

ferent keypads with different effects.

Main User This Code Type is reserved for Main Users, as it has full command of the

system: Global arming, Partitioning, Global disarming, Memory Reset,

Stop Alarm, Zone Bypass, Enable Teleservice and User Code PIN pro-

gramming.

User This Code Type allows Global arming / disarming and Reset Alarm Mem-

ory.

Duress This Code Type allows Global arming / disarming, and should be used in

the event of forced disarming, as this code will disable the system and acti-

vate the Telephone Dialler simultaneously.

Patrol This Code Type can disarm the partitions for the programmed Patrol time.

The partition will be rearmed automatically when the patrol time expires.

48 Security System Control Panels Omnia8/4

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 111 112

Keine Kommentare

Bentel Omnia 4 Spezifikationen Seite 48